I have a blank headbox and need to drill it for the 11" Marshall logo.
There is a thread that supports the 6"viewtopic.php?f=14&t=32352&p=464997&hil ... go#p464997, but that doesn't do me any good.
I've looked all over and even touched base with George, but to no avail.
As the 11" is used on both cabinets and head boxes, it would amaze me if anyone did not come up with a CAD/template for it and as indicated in other threads, it's not so simple as putting ink on the bottom of the pegs and making a template. The 11" is flimsy and flexes. If you want the lettering staright, you NEED a template.
Please advise and where I may procure this and thanks in advance.
This is what it sounds like, when cones cry.
1 post • Page 1 of 1