Finally got a run of these. I'll get some better pics the first of the week.
George
Plexi panels!!!
Moderator: VelvetGeorge
-
VelvetGeorge
- Site Owner
- Posts: 7233
- Joined: Tue Oct 14, 2003 5:12 pm
- Just the numbers in order: 13492
- Location: The Murder Mitten
- Contact:
Plexi panels!!!
- Attachments
-
- plexi frnt & rear.jpg
- (34.72 KiB) Downloaded 618 times
-
HCS
- New Member
- Posts: 5
- Joined: Wed Nov 05, 2003 7:55 pm
- Location: St Paul, MN
- Contact:
How Much? Will you drill the holes? Do you carry the fancy nuts for the switches?
Check out custom amps and Cabs at:
www.harrystraub.com/amps
www.harrystraub.com/amps
-
VelvetGeorge
- Site Owner
- Posts: 7233
- Joined: Tue Oct 14, 2003 5:12 pm
- Just the numbers in order: 13492
- Location: The Murder Mitten
- Contact:
I do drill the holes. I have purchased a set of high quality hole saws that will be used only for these panels.
The cost is $80 for a pair. I do stock the fancy nuts, they are $4 each.
I should note that these particular panels are the prototypes and are approx .070 thick. The actual production panels are approx .030 thick.
To put this into perspective, the reissue plexi panels are .020.
They just seemed too flimsy for my taste.
George
BTW I'll be offering a set of panels with a chassis at a discount.
The cost is $80 for a pair. I do stock the fancy nuts, they are $4 each.
I should note that these particular panels are the prototypes and are approx .070 thick. The actual production panels are approx .030 thick.
To put this into perspective, the reissue plexi panels are .020.
They just seemed too flimsy for my taste.
George
BTW I'll be offering a set of panels with a chassis at a discount.