Metropoulos Forum

Posted: **Thu Sep 27, 2012 4:15 pm**

FIXED!!!!!!!!

The second channel wire going to pin 2 got pinched under the board between the nut and the board. Some of the shielding got scraped back and a small amout of wire was making contact with the standoff. I replaced it and now we're making rockings. Channel 1 is a little to bright for me. Do raise or lower the value of the bright cap to tame this?

Posted: **Thu Sep 27, 2012 4:47 pm**

Congrats!
Assuming bypass cap, increase value to thinker things up.

Posted: **Thu Sep 27, 2012 5:27 pm**

Thank you everyone for your help. I settled on a 47pf bright cap on the channel 1 volume pot. Amp sounds great and is very quiet.

Posted: **Thu Sep 27, 2012 6:17 pm**

Good call, OnTheFritz! I had a similar problem with an NFB wire once. It's always the last thing you suspect.

Posted: **Thu Sep 27, 2012 10:25 pm**

In my excitement I neglected to thank On The Fritz. Thank you sir!!!!

Neikeel, thank you for getting my bias straight. I definitely would not have been able to figure that out on my own.

Dan

Posted: **Thu Sep 27, 2012 10:57 pm**

Fever Dog wrote:In my excitement I neglected to thank On The Fritz. Thank you sir!!!!

No worries, glad you got it worked out!

Metropoulos Forum

No sound channel 2. New build FIXED!!!!!

Re: No sound channel 2. New build

Re: No sound channel 2. New build FIXED!!!!!

Re: No sound channel 2. New build FIXED!!!!!

Re: No sound channel 2. New build FIXED!!!!!

Re: No sound channel 2. New build FIXED!!!!!

Re: No sound channel 2. New build FIXED!!!!!