Marshall PCB board layout
Posted: Fri Jan 27, 2017 5:13 pm
Does anyone have the layout for a Marshall ST1 PCB? I am particularly interested in the under board trace layout. Trying to figure out which end of the (2) 10k decoupling resistors (middle of the board) feeds the v1 anodes?
I just need a good pic of the top side of an unpopulated board (so I can see the traces thru it), or a pic of the under side of the board. Trying to see how the B+ is arranged as it goes thru the (2) 10k resistors in the center of the board. It looks like it comes from the PI to the pot side of the nearest 10k, thru that to the CF anode resistor and the tube side of the other 10k, then thru that 10k on to v1 anode resistors? Just trying to figure out if that is right?
I just need a good pic of the top side of an unpopulated board (so I can see the traces thru it), or a pic of the under side of the board. Trying to see how the B+ is arranged as it goes thru the (2) 10k resistors in the center of the board. It looks like it comes from the PI to the pot side of the nearest 10k, thru that to the CF anode resistor and the tube side of the other 10k, then thru that 10k on to v1 anode resistors? Just trying to figure out if that is right?