Anybody familiar with this schematic? Incredible Hulk

slashl33t · Post by **slashl33t** » Wed Apr 18, 2012 1:24 am

Found this schematic recently and I was wondering if anybody have tried specs close to this and how what were the results?

Cheers

herbvis · Post by **herbvis** » Wed Apr 18, 2012 2:56 am

slashl33t wrote:Found this schematic recently and I was wondering if anybody have tried specs close to this and how what were the results? Cheers

I think that might be the ceriatone elchupacabra

slashl33t · Post by **slashl33t** » Wed Apr 18, 2012 1:19 pm

idk man i dont think the chupa ever had a pussy switch lol

herbvis · Post by **herbvis** » Wed Apr 18, 2012 2:26 pm

Check the ceriatone chupacabra manual page 15 i think

Spark Gap · Post by **Spark Gap** » Fri Apr 27, 2012 11:45 am

The chupacabra has a 1meg trim pot on the inside they call the pussy pot. It's just forms a variable voltage divider between stages 2 and 3.

ezs · Post by **ezs** » Fri Jan 18, 2013 3:01 pm

Seems like all links down, looking for the Chupa schematic, can someone please PM me one? Or, if Hulk is it, please let me know? Thanks Z

ivan H · Post by **ivan H** » Sat Jan 19, 2013 7:14 pm

Hi, I just checked the schematic against a chupa schematic I got from another thread on this forum,,, its similar, but the chupa doesnt have the grind & girth controls after the first gain stage, instead it has just a gain control consisting of a 1 meg pot, & the "focus" switch consisting of an 82k & 1meg resistors (in series) off the pots wiper to earth, with a switch that shorts the 1meg resistor. Cheers

ezs · Post by **ezs** » Sun Jan 20, 2013 10:07 pm

So I did get the Chupa PM'd and noticed the heaters. The Hulk schem shows DC regulated vs hum pot on Chupa, anyone tried this DC w/7806 regulator? I ordered a few of the IC's to try.

jerrydyer · Post by **jerrydyer** » Tue Jan 22, 2013 1:05 pm

whatever it is it has cameron jose all over it.

metalhead3ecr · Post by **metalhead3ecr** » Thu Jan 24, 2013 6:41 pm

Mike fortin hulk mod?

metalhead3ecr · Post by **metalhead3ecr** » Thu Jan 24, 2013 7:04 pm

[youtube]http://www.youtube.com/watch?v=cYM-W3vYOUE[/youtube]

ezs · Post by **ezs** » Thu Jan 24, 2013 7:10 pm

Just youtubed the Fortin Hulk (orange 1959) very nice! From what I gathered so far, not sure of correctness, but this seems a Chupa spec with a tone network after the 1st gain stage? (Bassman w68k slope) Then it looks like a Chupa for the rest? Correct me if Im wrong.

volcomstone · Post by **volcomstone** » Mon Feb 26, 2018 3:16 pm

sorry to post on an old topic, I'm new to the forum and seeking any Fortin schematics possible. If anyone happens to have any that would be amazing or even the schematic from this topic would be more then enough

ezs · Post by **ezs** » Tue Feb 27, 2018 3:42 pm

I believe this schematic was tried and end result was lack of gain and a dud. Tone network sucked the life out of the first stage. I believe the schematic was a thought and not confirmed as the real mod. As I recall a previous thread I read at SLO.

Metropoulos Forum

Anybody familiar with this schematic? Incredible Hulk

Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Question about PTP boards on WIKI

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk

Re: Anybody familiar with this schematic? Incredible Hulk