3 wires on one turret?

planetjimi · Post by **planetjimi** » Fri Mar 09, 2007 1:57 pm

How am I to do this? Obviously only one wire can come up through the whole. Every pic I see of this area of the board there is only one wire and no hint of anything else. So I guess I just want to confirm that the diagram is correct and that two wires have to go up through the bottom, while one wire comes up on top.
Thanks

Guitar Adjuster · Post by **Guitar Adjuster** » Fri Mar 09, 2007 2:18 pm

You don't have to put them in the turret at all. You can solder them together and shrink wrap them and place them under the board for a neater appearance. If you do want to put them in the turret 2 on the bottom and one on the top or any combination will work.

miguel · Post by **miguel** » Fri Mar 09, 2007 2:19 pm

It's really tight, but I managed to cram (3) 20 ga. stranded into the bottom of a large split turret. Solid wire would probably be easier.

planetjimi · Post by **planetjimi** » Fri Mar 09, 2007 4:12 pm

Thanks!