2204 conversion to ptp

moger777 · Post by **moger777** » Sun Mar 26, 2006 5:29 pm

alright, I got my board kit but not sure what mastervolume pdf I should use on the cd that came with the kit. Any advice?

Guitar Adjuster · Post by **Guitar Adjuster** » Sun Mar 26, 2006 7:50 pm

Try this link and download the 2204 PDF. It's the one I am using for my 2204 PTP conversion.

http://homepage.mac.com/gaden/Amps-n-st ... ing15.html

Allen

KMC · Post by **KMC** » Mon Apr 10, 2006 1:26 am

moger777 wrote:alright, I got my board kit but not sure what mastervolume pdf I should use on the cd that came with the kit. Any advice?

Take Notice to the recitfier bridge and input resistor. The 2204/03 curcuits are the same except those 2 items. 2204 takes a 220k resistor and half wave rec.

Guitar Adjuster · Post by **Guitar Adjuster** » Thu Apr 20, 2006 6:44 pm

Here is a photo of my 1980 2204 PCB to Point to Point....almost done!

Allen

KMC · Post by **KMC** » Thu Apr 20, 2006 8:22 pm

Hard to tell from the pic, But take a look at your rectifier bridge. Looks like you may have it wired wrong. The Diode's look oriented correctly for a half wave,But it looks like you have a extra piece of bus wire on the end where the standby wires should be wired. DEFINITELY DOUBLE CHECK THIS B4 YOU FIRE IT UP !!

Here's a pic of mine.(Note: This is from when it was in a Laney. The purple wires are the standby wires)

Guitar Adjuster · Post by **Guitar Adjuster** » Thu Apr 20, 2006 10:12 pm

Thanks KMC,

I changed it in time, this board was actually for a 100 watter but I changed my mind and put in in my 2204.

Allen

RedHouse · Post by **RedHouse** » Thu Aug 31, 2006 9:30 pm

Does any of you still have your 2204 PCB?
(please PM me if you do)

Metropoulos Forum

2204 conversion to ptp

2204 conversion to ptp

Re: 2204 conversion to ptp