confusion about my circuit board

TomGibbs · Post by **TomGibbs** » Sun Jul 01, 2007 11:43 am

hey guys

im at the stage now, where i am ready to wire the circuit board, but my circuit board doesn't seem to follow George's in the notes

it seems like mine is shorter, and there isnt enough posts.

i hope these pictures show.

Flames1950 · Post by **Flames1950** » Sun Jul 01, 2007 12:08 pm

That board's mounting hole spacing make it look like it's a board kit for putting in a PCB Marshall.......not what you needed? It doesn't have the stuff for the two .22uF caps at the right end of the board if that's the question.

TomGibbs · Post by **TomGibbs** » Sun Jul 01, 2007 12:16 pm

Flames1950 wrote: It doesn't have the stuff for the two .22uF caps at the right end of the board if that's the question.

thats what i thought

could i still use this one? or would i need to get another one??

neikeel · Post by **neikeel** » Tue Jul 03, 2007 8:51 am

You can use it.

You may not need to use the snubber caps on the far right of the board as I believe that newer diodes are not as noisy.