Page 1 of 1

New sub-forum for Valvestorm!

Posted: Tue May 21, 2013 1:22 pm
by VelvetGeorge
This is where we will post info on products, ordering, availability, upcoming products etc all related to Valvestorm.com

Robert is your resource and should be your first stop for DIY parts. I'll continue to make more of my old parts available through his store and appreciate his great service.

Many chassis are in the works, so keep an eye here for those.

george

Re: New sub-forum for Valvestorm!

Posted: Tue May 21, 2013 6:17 pm
by JimiJames
JimiJames wrote:Man ! This is very good news ! This is sure to motivate ! It's starting to feel like the old store. The good ole days yea !
Image
Cheers to Robert and George !
:toast:

Re: New sub-forum for Valvestorm!

Posted: Wed May 22, 2013 7:46 pm
by ValveStorm
Thank you George and JimiJames!
:worthy:
I hope that this forum will help with info about ValveStorm parts and other products.
For personal attention to customers questions and order status, please email me at admin@valvestorm.com
If you do email, and I do not not get back to you right away, please email again. I get a lot of requests for info that require research... sometimes I get swamped and or side-tracked.

Thanks!
Robert

Re: New sub-forum for Valvestorm!

Posted: Thu May 23, 2013 12:38 pm
by VelvetGeorge
We're lucky to have you Robert, thanks for keeping these DIY parts available.

This section is the place to organize you requests for parts. If there's enough demand for a certain chassis, board, panel etc we can try to get them made. I'll do my best to provide the specs and files. We can work up stuff too, like we did for the Valvestorm custom chassis. 25 pieces minimum, but the best price point is at 50 or more.

george

Re: New sub-forum for Valvestorm!

Posted: Mon May 27, 2013 2:29 pm
by Maschinenmann
Was interested in the aluminum 45 chassis, but you are out of stock- any idea when you'll have another batch arriving?

Re: New sub-forum for Valvestorm!

Posted: Tue May 28, 2013 12:24 pm
by ValveStorm
I started another thread to keep folks updated on chassis availability.

Re: New sub-forum for Valvestorm!

Posted: Mon Jun 17, 2013 2:22 pm
by vanhalen5150
Have you looked into the vintage zinc plating/powder coat?

Re: New sub-forum for Valvestorm!

Posted: Fri Jun 21, 2013 12:11 pm
by Strat78
Robert, are there period correct front panels available for a JTM 45/100? I guess they are basically a JTM 45 with the MKII by the inputs?

Re: New sub-forum for Valvestorm!

Posted: Sat Jun 22, 2013 8:23 am
by ValveStorm
vanhalen5150 wrote:Have you looked into the vintage zinc plating/powder coat?
You mean zinc oxide? I guess you would need a clear zinc plated chassis, and just let it rust! Might be ways to accelerate that.
Strat78 wrote:Robert, are there period correct front panels available for a JTM 45/100? I guess they are basically a JTM 45 with the MKII by the inputs?
Most folks use the Sparky JTM45 for the front. I have made quite a few backs... Hey! weren't you supposed to get TWO of those chassis?