I searched but did not find a definitive answer if you can run a stock JTM 45/100 (1202-84 and 1204-43 [lower secondary ~500v B+]) with EL34s.
Trying to figure out if this is just a bias change or do you have to use a different OT tap too.
Any help is much appreciated
Thanks
Rip
1202-84 with EL34s
Moderator: VelvetGeorge
- bill bokey
- Senior Member
- Posts: 490
- Joined: Sun Jan 02, 2011 2:54 pm
- Just the numbers in order: 13492
- Location: France
- Contact:
-
- Senior Member
- Posts: 567
- Joined: Tue May 13, 2008 1:14 am
Re: 1202-84 with EL34s
bill bokey wrote:viewtopic.php?t=36683
Thanks, I saw that post but didn't see a definite answer to whether or not it is solely a bias tweak and/or a impedance change was needed too.
Rip