I'm putting one of George's JTM45 RI replacement boards in a Traynor Bassmaster. In essence, all I'm keeping from the Traynor are the big Hammond trannys, the chassis, and case.
As such, I've been using a combo of the RI instructions and the JTM45 kit instructions to wire the thing up. That worked fine until I got to the point of wiring stuff to the 16uf and 32uf caps - where I can't figure out what goes where because the instructions are way different at that point. Who can give me some guidance?
Dan
Filter cap questions
Get support and show off your MetroAmp JTM 45 kit builds.
Moderator: VelvetGeorge
-
- New Member
- Posts: 9
- Joined: Fri Apr 09, 2004 11:58 am
Return to “MetroAmp JTM 45 Kits”
Jump to
- Website, Forum, Store and Products
- ↳ MetroAmp Store and Site
- ↳ General Beginner's Questions
- Amplifiers, Kits, Parts and Tech
- ↳ Plexi Replicas by Metropoulos Amplification
- ↳ Metro-Plex
- ↳ MetroAmp General Kits and Products
- ↳ MetroAmp JTM 45 Kits
- ↳ MetroAmp 50 Watt Kits
- ↳ Metroamp 100 Watt Master Volume Kits
- ↳ Marshall Amplifiers
- ↳ Other Amplifiers
- ↳ Do It Yourself amp builds
- ↳ Repairs, Restoration and Mods
- ↳ Transformers and Chokes
- ↳ PTP circuit boards
- ↳ Tubes
- Gear and Artists
- ↳ Eddie Van Halen Amp Builders
- ↳ General EVH & Van Halen Discussion
- ↳ James Marshall Hendrix
- ↳ Artists
- ↳ Pedals and Gear
- ↳ Speakers and Cabinets
- ↳ Guitars
- Community
- ↳ Business Classifieds and Product Announcements
- ↳ Valvestorm Products and Info
- ↳ Member Classifieds
- ↳ Off topic
- ↳ Sound and Recording
- ↳ Video and Sound Clips
- Technical Reference
- ↳ 45/100 Build Journal
- ↳ Marshall Schematics
- ↳ Circuit Board layouts
- ↳ Transformer Wiring Diagrams
- ↳ Amp and Kit Info
- ↳ 12-Series Build Journal