A thought on power transformers...

jtm-45/dr504 · Post by **jtm-45/dr504** » Sun Feb 12, 2006 12:45 pm

So, what voltage does your JTM-45 (or clone thereof) put on the plates?

My reissue reads about 403, which I've always been happy about, since I assumed this was easier on the tubes an also meant my amp might be a bit quieter volumewise. Is this a correct assumption? What do you guys think?

Flames1950 · Post by **Flames1950** » Sun Feb 12, 2006 2:48 pm

My Metro clone runs about the same, around 402VDC. I doubt it's significantly quieter but might be a bit more compressed than a JTM45 running at 450VDC.