Bias question

Get support and show off your MetroAmp JTM 45 kit builds.

Moderator: VelvetGeorge

Post Reply
PaulO
New Member
Posts: 8
Joined: Thu Feb 16, 2006 7:43 am
Location: Syracuse, NY USA
Contact:
Contact PaulO

Bias question

Post by PaulO » Fri Feb 17, 2006 7:42 am

To bias a JTM45 reissue, does it require installation of a bias pot?
Top
User avatar
neikeel
Senior Member
Posts: 7231
Joined: Tue Dec 06, 2005 8:31 am
Location: Suffolk, England

Post by neikeel » Fri Feb 17, 2006 11:14 am

There should be one on the board. A small black arched plastic block with a white centre with a slot for small screwdriver.

Are you going to use a biasing tool in the sockets or the 1ohm resistor replacing the short buss between pin 8 and earth (1MILLIVOLT=1Ma across this resistor)?
Neil
Top
Post Reply

Return to “MetroAmp JTM 45 Kits”