Page 1 of 1
Strat Neck Heel
Posted: Tue Feb 12, 2008 10:58 pm
by IloveMyMarshall
Hey gang I got this hard ash body off sleezebay I have neck i want to put on her one problem got the body she is 2 1/4 heel I have 2 3/16? Is this doable and what do I need to do? I do not want to mess my strat neck up?
Thxs for any suggestions
Posted: Wed Feb 13, 2008 10:51 am
by 45auto
wouldn't you have to rout the body out wider? maybe divebomb or one of the guys here could do it if you don't have a shop setup?
Posted: Wed Feb 13, 2008 10:56 am
by IloveMyMarshall
45auto wrote:wouldn't you have to rout the body out wider? maybe divebomb or one of the guys here could do it if you don't have a shop setup?
Actually she has a gap the neck is stand. 2 3/16 the bode was 2 1/4 I thinking shim each side 1/16 and make damn sure she lines up before I start drillin holes on my brand new birds eye, hey where has ole Kyle been?? I have not seen him around?? Hey kyle if you are out there how much to do a top mount Floyd shelf, Im swapping necks on another axe that has the one and only FR I will use?
Hey do any of you guys still go over G101 George Mangos, had a killer lay out post on the F Rose route any of you here have that post or know where I can find that, it was beyond awesome step by step.
Posted: Wed Feb 13, 2008 5:07 pm
by 45auto
ooh right, sorry i misunderstood. that might be a little funky shimming it in like that. it seems like it could be done.