Page 1 of 1
JCM 800 Plexi Panel - will this work?
Posted: Tue Feb 26, 2008 1:15 pm
by kannibul
On a Metro Plexi Kit, converted to a JCM 800...
Would this fit:
http://www.ceriatone.com/images/complet ... N1805B.jpg
According to Nic @ Ceriatone
I am not very sure, but I think most likely, yes, it will fit. We do use the vintage marshall dims. I cant be 100% sure though.
For $20 + shipping from Asia, might it be worth a shot?
I just need to order a Metro kit!
EDIT: Hmm, just noticed the labels are out of order
Posted: Tue Feb 26, 2008 1:43 pm
by chubs
odds are the holes would align correctly... even just 1/2 a mm and it will not fit...
You're right, ceriatones stuff in not expensive. I have ordered at least 5 times from him... prices are dirt cheap.
Edit: just order th whole kit... aobut $450.
Posted: Tue Feb 26, 2008 7:38 pm
by Guitar Adjuster
Were are you located? I got a Ceriatone JCM800 panel in my Garage, Don't have a Metro chassis here right now to check the alignment.....
Posted: Tue Feb 26, 2008 10:05 pm
by kannibul
Guitar Adjuster wrote:Were are you located? I got a Ceriatone JCM800 panel in my Garage, Don't have a Metro chassis here right now to check the alignment.....
I'm just south of Tulsa - we're not too far - lol...
I don't have a kit even on order yet - wish I did...but I'm still debating on which direction (which kit, what caps, which transformers...)
If you can hang onto the panel for a bit, I may be placing an order tonight or tomorrow - I want to hear back from George if he has everything in stock...
