standup PT wire diagram
Posted: Fri May 09, 2008 11:10 pm
since my PT doesnt have white or green wires on the primary side - im wanting to find out if im assuming the color scheme correctly.
Metropoulos Forum
The place for vintage amp discussion.
https://forum.metropoulos.net/
standup PT wire diagram
Page 1 of 1
Posted: Fri May 09, 2008 11:53 pm
Almost, the two solid blues are bias. Blue with reddish stripes are 400V taps.
Posted: Sat May 10, 2008 1:04 am
well thats where i got confused i figured both taps would be schemed together as far as plain colors but then it makes sense that the blues are bias....but u are ya sure Steve?SDM wrote:Almost, the two solid blues are bias. Blue with reddish stripes are 400V taps.
plain red = 500dcv tap
blue bias
blue/purple is 400dcv tap
red/yellow CT
Posted: Sat May 10, 2008 2:03 am
Just put one in, so yeah that's how it was wired. Actually it may have that PT in the new 100 watter instructions Andy redid too, now that I think about it.
Of course you know how George likes to keep you on your toes with color codes
Of course you know how George likes to keep you on your toes with color codes
Posted: Sat May 10, 2008 2:28 am
seems the color codes change quite a bit;) - thanks Steve.
Posted: Sat May 10, 2008 8:09 am
Yes, that amp is on my bench being modded right now -- blue w/stripe are the low voltage taps, solid blues are the bias.SDM wrote:Actually it may have that PT in the new 100 watter instructions Andy redid too, now that I think about it.
Posted: Sat May 10, 2008 11:57 am
thanks guys!