Page 1 of 1
Orange lamp
Posted: Fri Jul 24, 2009 4:56 pm
by Vegard
Hi!
I am currently building a 45/100. I want to use the orange lamp(120V) and not the red 6V.
My question is, what do connect i to. If its possible at all...
VB
Re: Orange lamp
Posted: Fri Jul 24, 2009 5:30 pm
by Roe
connect to the 120v primary and the com. connect the wall power to com and 230v. see 50w instructions for diagram
Re: Orange lamp
Posted: Fri Jul 24, 2009 7:06 pm
by Vegard
My 120V primary is connected to a voltage selector.
Can this still be done?
Re: Orange lamp
Posted: Fri Jul 24, 2009 7:58 pm
by Flames1950
Yes!
Re: Orange lamp
Posted: Sat Jul 25, 2009 7:23 am
by Vegard
So i have to run a wire from the lamp to the 120V on the selector, and connect the other wire on the lamp to com.?
Re: Orange lamp
Posted: Sat Jul 25, 2009 10:53 am
by neikeel
Just hook the lamp direct to the PT lugs (common and 120v tap), no need to run the wire (with A.C.) all across the amp if you do not have to
Re: Orange lamp
Posted: Sun Jul 26, 2009 9:04 am
by Vegard
Ok, thanks!
Roe, when i look at your build pics, i can see i have mounted my PT 180 degrees from what you have. Does that have anything to say?
Re: Orange lamp
Posted: Sun Jul 26, 2009 11:22 am
by Roe
well, I used a different PT - the marstran. rotating the PT may have something to say, yes. shakti tried rotating the PT