JTM 45/100 build on a Marstran chassis

[ValveStorm]

Looking forward to this build! Still waiting for the PT, but I have the chassis!
Here is the backplate I made for this build, mounted on Brian's chassis:

You may need to click on each picture to see the pic without truncation.


I left the AC inlet at power cord size it can be trimmed out to accommodate any size conector.


I had this one made with a serial number, I have a few more of these wo/ the ser# if there is any interest: admin@valvestorm.com

[Spodeeodee]

Those panels are looking good. I'll email you about pricing.

Regarding Brian's chassis, I'm not able to find any info for them on marstran.com. How do you go about ordering them?

[Xplorer]

it was a 10 pieces run, if some other 10 peoples are interested, i suppose that Brian would accept to have them made again.