Page 2 of 2
Re: Help on Night Owl's Step 10 instructions
Posted: Mon Oct 12, 2015 9:34 pm
by dante
Thanks guys for all your help! Everytime I am getting a step closer. I instlled the purple wire from the presence pot to the board and now I am getting presence and full volume on Volume II. I was playing on it for a while tonight. Volume I high and low still doesn't increase or decrease it just has the same volume. Any ideas?
Re: Help on Night Owl's Step 10 instructions
Posted: Fri Dec 04, 2015 10:12 am
by dante
Anybody have any ideas on why the volume I high and low still doesn't increase or decrease it just has the same volume. This is my first build
Re: Help on Night Owl's Step 10 instructions
Posted: Fri Dec 04, 2015 1:02 pm
by neikeel
Need some pics of your pot wiring
Re: Help on Night Owl's Step 10 instructions
Posted: Sat Dec 05, 2015 2:47 pm
by axeman
dante wrote:Anybody have any ideas on why the volume I high and low still doesn't increase or decrease it just has the same volume. This is my first build
Your bright capacitor on the volume pot might be faulty or soldered poorly. Move it, then turn the amp and see what it does, if continues remove it. Those capacitors suck.
Re: Help on Night Owl's Step 10 instructions
Posted: Mon Dec 07, 2015 9:19 am
by dante
Thanks folks for giving some feedback. I am going to check the capacitor today and takes some pics of the pot wiring. Appreciate all the help.
Dante