I am sure this was covered somewhere but I could not find it.
I would like to know where to wire an input that I can go into from a separate preamp on a 100 Plexi Metro kit.
In other words just use the power section of the amp.
Jerry
Using power section only.
Moderator: VelvetGeorge
-
- Senior Member
- Posts: 231
- Joined: Wed Feb 18, 2009 7:18 am
- Just the numbers in order: 7
- neikeel
- Senior Member
- Posts: 7231
- Joined: Tue Dec 06, 2005 8:31 am
- Location: Suffolk, England
-
- Senior Member
- Posts: 231
- Joined: Wed Feb 18, 2009 7:18 am
- Just the numbers in order: 7
Re: Using power section only.
neikeel wrote:The effects loop in would work
You know, I always wanted to try one of those, I guess this would be a good excuse. Thanks.
-
- Senior Member
- Posts: 231
- Joined: Wed Feb 18, 2009 7:18 am
- Just the numbers in order: 7
Re: Using power section only.
I just noticed the Metro store is not open yet, do you know where I can get a kit?
- Ferrari-Dude
- Senior Member
- Posts: 98
- Joined: Sat Feb 17, 2007 12:17 am
- Just the numbers in order: 13492
- Location: West Chester, OH
Re: Using power section only.
Try contacting George through Facebook.Jerry G wrote:I just noticed the Metro store is not open yet, do you know where I can get a kit?
-Dono
1972 Marshall Super Bass
"Can you hear me now?"
1972 Marshall Super Bass
"Can you hear me now?"
-
- Senior Member
- Posts: 76
- Joined: Mon Jan 31, 2011 1:23 pm
- Just the numbers in order: 13492
- Location: Atlanta, GA
Re: Using power section only.
maybe a dumb question here but couldn't he tap into the circuit at the point where the effects loop comes back in without buying a loop? On the other hand if your amp doesn't have a loop, put one in you wont regret it. But for the sake of general knowledge would that be the point of entry into the circuit?
- neikeel
- Senior Member
- Posts: 7231
- Joined: Tue Dec 06, 2005 8:31 am
- Location: Suffolk, England
Re: Using power section only.
Yes it would be easy enough, still involves dilling a hole and tapping in where the pre-PI MV pot wiper would go.
He could do it with a make/break switching jack/
The loop is more elegant and pretty useful IMO
He could do it with a make/break switching jack/
The loop is more elegant and pretty useful IMO
Neil