Page 1 of 1
Using power section only.
Posted: Fri May 16, 2014 11:15 am
by Jerry G
I am sure this was covered somewhere but I could not find it.
I would like to know where to wire an input that I can go into from a separate preamp on a 100 Plexi Metro kit.
In other words just use the power section of the amp.
Jerry
Re: Using power section only.
Posted: Fri May 16, 2014 1:37 pm
by neikeel
The effects loop in would work
Re: Using power section only.
Posted: Fri May 16, 2014 2:57 pm
by Jerry G
neikeel wrote:The effects loop in would work
You know, I always wanted to try one of those, I guess this would be a good excuse. Thanks.
Re: Using power section only.
Posted: Fri May 16, 2014 2:59 pm
by Jerry G
I just noticed the Metro store is not open yet, do you know where I can get a kit?
Re: Using power section only.
Posted: Wed May 21, 2014 8:22 am
by Ferrari-Dude
Jerry G wrote:I just noticed the Metro store is not open yet, do you know where I can get a kit?
Try contacting George through Facebook.
Re: Using power section only.
Posted: Wed May 21, 2014 8:33 am
by redgtr
maybe a dumb question here but couldn't he tap into the circuit at the point where the effects loop comes back in without buying a loop? On the other hand if your amp doesn't have a loop, put one in you wont regret it. But for the sake of general knowledge would that be the point of entry into the circuit?
Re: Using power section only.
Posted: Wed May 21, 2014 10:06 am
by neikeel
Yes it would be easy enough, still involves dilling a hole and tapping in where the pre-PI MV pot wiper would go.
He could do it with a make/break switching jack/
The loop is more elegant and pretty useful IMO
