General Beginner Answer:1st set B+ at a sane level in preamp
Posted: Fri Dec 04, 2015 2:15 pm
Please don't hold it against me for bringing this up
again.
When finished with a build, before dialing in tone.
make sure bias voltages are sane values.
i.e. pre-amp B+ set to 300 VDC(a couple under won't hurt).
mines at 296 VDC, used a 15.3k drop to achieve this(originally 10k).
Can't chase tone dragons till the sword is sharp,
let the fun begin!
again.
When finished with a build, before dialing in tone.
make sure bias voltages are sane values.
i.e. pre-amp B+ set to 300 VDC(a couple under won't hurt).
mines at 296 VDC, used a 15.3k drop to achieve this(originally 10k).
Can't chase tone dragons till the sword is sharp,
let the fun begin!