Page 1 of 1

Metroplex 100 Boost mode

Posted: Sat Feb 11, 2017 2:16 am
by eddyrox
Reading reviews on the MetroPlex 100 and noting that the boost controls have internal trim pots on board to add/cut bass and treble? Looking to confirm this is still the case :thumbsup: :thumbsup: :thumbsup:

"...the solo boost function. However, if you prefer some bass/treble roll-off you can adjust that. Inside the chassis there are two trim pots on the board for the solo boost that allow you to add/cut bass or treble for the boost section."

Re: Metroplex 100 Boost mode

Posted: Sat Feb 11, 2017 10:55 am
by eddyrox
...never mind - file this in the "stupid question" file :worthy:
found it.
:thumbsup:

Re: Metroplex 100 Boost mode

Posted: Wed Feb 15, 2017 12:46 pm
by VelvetGeorge
The cut trimmers are still in there, on the boost board. I thought people might want to cut highs and lows for a mid range boost.

On the Super-Plex I move these controls to the front panel and change the tone stack. There is more low end in that circuit, so the low cut becomes very important.

george

Re: Metroplex 100 Boost mode

Posted: Sun Feb 19, 2017 6:14 am
by eddyrox
VelvetGeorge wrote:The cut trimmers are still in there, on the boost board. I thought people might want to cut highs and lows for a mid range boost.
thank you George...awaiting some "purple" glory soon... :drool: :drool:
best, mike. :clap:

Re: Metroplex 100 Boost mode

Posted: Mon Feb 20, 2017 10:24 am
by VelvetGeorge
It's built, I'm just sorting out that extra low end option for you and Stephen.

george