Hi !
I have finish a new amp but I ve a problem with the Fx loop.
The fx loop can be switch. When the fx loop is on, I have a noise and when I UP more than 12 oclock the power in level, The amps starts to CRY and make lot of noise (OSCILATION NOISE).!
What can I do? The tube si a Tung sol 12ax7.
How I can reduce the signal?
subir fotos a internet
Thanks!
Big problem in Fx Loop
-
- New Member
- Posts: 28
- Joined: Thu Aug 20, 2015 4:32 am
- Just the numbers in order: 13492
Big problem in Fx Loop
Last edited by raza on Wed Jan 27, 2016 2:20 pm, edited 1 time in total.
-
- New Member
- Posts: 28
- Joined: Thu Aug 20, 2015 4:32 am
- Just the numbers in order: 13492
Re: Big problem in Fx Loop
The power in level Pot is a 250ka pot, same value for VOL pot.
-
- Senior Member
- Posts: 1099
- Joined: Tue Sep 10, 2013 9:09 pm
- Just the numbers in order: 13492
Re: Big problem in Fx Loop
Since you mentioned that it was a new amp, did you try to play it before installing the loop? The reason I ask is that it is common to have to swap the OT primary wires on new builds that exhibit this same problem. Usually swapping the wires going to pin 3 of the power tube sockets will fix the problem.
-
- New Member
- Posts: 28
- Joined: Thu Aug 20, 2015 4:32 am
- Just the numbers in order: 13492
Re: Big problem in Fx Loop
Hi,
It'snt problem from the wires of the Ot becouse when I Switch off the Fx loop, I bypass ther return Stage, and it sounds very good.
Also I test to put the guitar for the return, And the amp sound good, only with the power in Level.
I dont know whats happen....
It'snt problem from the wires of the Ot becouse when I Switch off the Fx loop, I bypass ther return Stage, and it sounds very good.
Also I test to put the guitar for the return, And the amp sound good, only with the power in Level.
I dont know whats happen....
-
- Senior Member
- Posts: 1099
- Joined: Tue Sep 10, 2013 9:09 pm
- Just the numbers in order: 13492
Re: Big problem in Fx Loop
Ok, just wanted to check that first. I don't have much experience with the loop so hopefully one of the fellas will have some suggestions.