Hi Guys,
I am sure this has been discussed here at sometime. I have seen a few different amp makers build a plexi with an option to switch between a lead and a bass circuit. I have a decent understanding of this in theory, but how is this done literally in terms of the amount of space used in the amp. I think I know how it would look on a schematic, but not so much on a layout. Any insight would be appreciated.
Thanks,
JR
Switching Between Lead and Bass Circuits on Plexi
-
- New Member
- Posts: 41
- Joined: Sat Dec 31, 2011 12:11 am
- Just the numbers in order: 7
-
- Senior Member
- Posts: 76
- Joined: Mon Jan 31, 2011 1:23 pm
- Just the numbers in order: 13492
- Location: Atlanta, GA
Re: Switching Between Lead and Bass Circuits on Plexi
Mojo has a complete switching setup. I have installed two of them they work well. Ran a toggle to the back of the amp so you could use a footswitch or toggle. Placed it in front close to the input jacks. it came with its own mounting hardware